一、实验拓扑图 二、R1设置IP <H3C>system-view System View: return to User View with Ctrl+Z. [H3C]undo info-center enable Information center is disabled. [H3C]sysname R1 [R1…
一、实验拓扑图 二、配置R1路由器 <H3C>system-view System View: return to User View with Ctrl+Z. [H3C]sysname R1 [R1]interface g 0/0 [R1-GigabitEthernet0/0]ip address 10.0.0…
一、实验拓扑图 二、配置第一台交换机 <H3C>system-view System View: return to User View with Ctrl+Z. [H3C]undo info-center enable Information center is disabled. [H3C]irf member 1 pri…
一、实验拓扑图: 注意:单臂路由一定要在路由器上创建vlan(根思科、华为不同) 二、设置交换机SW1 [H3C]undo info-center enable Information center is disabled. [H3C]sysname 2sw1 [2sw1]vlan 10 [2sw1-vlan10]v…
一、实验拓补图: 二、配置第一台交换机 [H3C]sysname device1 [device1]interface range Ten-GigabitEthernet 1/0/49 to Ten-GigabitEthernet 1/0/5 进入范围实际的1/0/49到1/0/50端口 0 [device1-if-rang…
一、实验环境: 二、配置交换机SW1 为混合链路 <H3C>system-view System View: return to User View with Ctrl+Z. [H3C]undo info-center enable Information center is disabled. [H3C]sysname SW…
链路聚合与vlan:适用于双千兆、光纤 目的是:一条线坏了,可以走备用(第二条)线 一、实验拓朴图: 二、设置PC IP: 三、配置交换机SW1 <H3C>system-view System View: return to User View with Ctrl+Z. [H3C]sysname SW1 [SW1]vlan 1…
一、实验拓扑图 二、配置PC IP: 三、配置路由器 [H3C]sysname 3SWS1 [3SWS1]sysname 3SW1 [3SW1]vlan 10 [3SW1-vlan10]vlan 20 [3SW1-vlan20]vlan 30 [3SW1-vlan30]quit [3SW1]i…
一、实验拓扑图: 二、设置PC IP 三、设置路由器SW1 [SW1]vlan 10 【创建vlan10】 [SW1-vlan10]vlan 20 【创建vlan20】 [SW1-vlan20]exit [SW1]interface g 1/0/2 [SW1-GigabitEthernet1/0/2]port…
一、实验拓扑图 图标变绿色,即为设备启动了 二、配置路由器 MSR36-20_1 <H3C>system-view System View: return to User View with Ctrl+Z. [H3C]sysname R1 [R1]interface g 0/0 [R1-GigabitEthern…